$648.95 – Single Band USA (GSM,CDMA,GPRS,EDGE)
$648.95 – Single Band Global (GSM)
$648.95 – Single Band Global (GSM,DCS)
$648.95 – Single Band USA (GSM,PCS,CDMA,EDGE,3G)
$648.95 – Single Band Global (UMTS, 3G, WCDMA)
$813.95 – Dual Band USA (GSM,CDMA,GPRS,PCS,3G)
$813.95 – Dual Band Global (GSM,DCS)
$813.95 – Dual Band Global (GSM,3G,UMTS,WCDMA)
$692.95 – Single Band USA (AWS,3G)
**prices do not reflect shipping or taxes.
The Indoor Cellular Repeater Kit with Pre-Amp is supplied
with all of the components needed to provide coverage for rural applications where
outdoor reception is weak. At its heart is a feature-filled Full Duplex Repeater.
The kit includes:
Yagi Panel Donor Antenna
45ft Low-Loss Coax (5D-FB)
WCB Pre-Amplifier with Power Supply & Signal lead
JD55-PR Repeater & Power Supply
Coax Seal
User Manual
Warranty Card
This kit was specifically designed for customers who are located in weak reception areas. With the use of a pre-amp that is placed inline with the donor antenna and the base repeater, the signals are amplified and filtered to provide you the level you once thought was not possible. The system is pre-set to ensure seamless integration with the cellular network.
To maintain safe and specific output signal levels, this advanced repeater has built-in AGC and ALC circuits, which can automatically control the gain of the repeater within a 15dB range depending on environmental conditions. In addition, it also has built-in attenuation dip switches that allow you to manually attenuate (fine tune) the repeater’s uplink and downlink channels in 1db steps up to 31dB, using color changing LED’s as a status indicator.
These Alarm LED’s are used as a guide to prevent your installation from re-producing errors due to excessive input signal strength if a pre-amp is used, or from signal oscillation due to the indoor antenna and outdoor antenna being too close to each other, which can have adverse effects on a base station.
A Network Safe / MUTE Feature has also been added to this repeater to protect the cellular network. In short, the repeater will stop transmitting if any errors or signal oscillation is detected within 2 sec of detection. It will cycle for 30 sec then attempt to transmit again. If no adjustment in gain has been made to correct the error within the 30sec MUTE cycle, the system will again shut down after 2 sec. It will run this sequence for a total of 3 times and then shut down completely. Unplugging and powering back up the unit will reset this sequence.